- 17-4 Stainless Steel
 - Large Cavity-Back
 - Patented Aim Indicator
 - Enhanced Tight-Radius Sole
 - Progressive Hosel Offset
 - Oversized Sweet-Spot

The AT505 is a game improvement Iron and an excellent choice for any golfer who's wear mark on the face of their irons is larger than a quarter.  It's larger size, cavity-back and sweet-spot help insure that even mis-hits can go long and straight.

The perimeter weighting of the large cavity-back greatly increases the size of the sweet-spot.  This design feature auto corrects off center hits that would otherwise go off target and fall short.    The progressive off-set hosel positions your hands slightly in front of the ball and allows the club to catch up to your swing. This gets the face closed sooner and reduces weak shots to the right.

The strength of the high-grade 17-4 Surgical Stainless Steel gives the 505 it's large forgiving sweet spot and power.  The deepness of the back cavity moves the center of gravity lower and farther behind the face to help the ball get higher in the air.  The cavity-back becomes progressively more pronounced in the longer irons, where face impact accuracy is more difficult.

The 505's beveled sole with tight radius was designed to help prevent the club from catching and digging into the grass.  The thicker top-plane of the 505 gives the head a strong look, giving the golfer more confidence during each shot.

All these features of the AT505 work together to greatly improve the performance, accuracy and distance of the average player.  Golfers at this level will experience a higher performance consistency with the AT505 than a Player's design.

The AT602 is a Player's Iron and should be used by consistent ball-strikers.  It's smaller size, cavity-back and sweet-spot offer multiple advantages to accurate ball-strikers.

The smaller head and concentrated mass of the 602's will produce a sweeter and more productive shot for accurate ball-strikers.  This Player's-club design also allows the golfer to “work” their shots utilizing draws, fades and knockdowns, that would otherwise be corrected by larger Game-Improvement cavity-back designs. The small head size also reduces drag through grass, rough and sand. The low 1.5mm hosel offset of each 602 will increase club effectiveness and prevent the tendency of shots going too far left.

Along with the smaller head and concentrated mass, the 602's have incorporated a slight cavity-back to improve shot accuracy on those occasional mis-hits.  This professional cavity-back design feature becomes progressively more pronounced in the longer irons, where face impact accuracy is more difficult.

Another big advantage of the 602 design is the exceptional “Feel” at impact, communicating through the shaft and to the hands. This gives a high degree of feedback to the player as to just what the head did through impact. As the ball leaves the face, an experience player will know exactly what has transpired, and be able to utilize the input to fine tune their game.

The 602 has a thinner top-plane for a slimmer look at address, and a  sole designed to augment the abilities found in the game of better players; ground to compliment the typical movement through impact that most scratch players demonstrate.